bumper help/measurements

Discussion in 'The Garage' started by Pow06er, Sep 24, 2005.

  1. Pow06er

    Pow06er 1/2 ton status

    Apr 9, 2005
    Likes Received:
    ne, ohio
    I need some measurement to get ideas for a warn plate style bumper i want to try and make with help of my uncle.

    I'm just looking for a rear bumper made out of 3/16 steel with a receiver hitch and some clevis or watever they are made from 1/2" or 3/8ths steel.

    and a front bumper with clevis's

    heres a crappy pic of want im looking for


    im just wondering if i should measure my stock bumpers and go off them as far as width?

    is there anything I should told about before I go and try and make these?

    wats the best way to use the stock bracketry?

Share This Page