buy one, get one free grinder deal..

[ryoken]

thought i'd throw this over here for more coverage than the Tool section cuz I don't know how long they'll run the price...

pretty smoking deal going on at tractor supply.... I bought a pair last night...

2 7.5 amp 4 1/2" dewalt grinders for $99...


https://www.tractorsupply.com/tsc/p...witch-small-angle-grinder-2-pack?cm_vc=-10005

 

[Bent77]

Dang! If I didn’t already have 5 I’d buy more!

 

[ryoken]

Dang! If I didn’t already have 5 I’d buy more!

yeah, i only have one at a time generally..... same dewalt but with the side switch... it'll be nice to set all 3 up with various death implements and not be looking for the wrench every 10 minutes...

the money definitely could have been used elsewhere, but I couldn't pass it up....

 

[toomany]

Airgas started running this deal earlier this year. I bought two. I've got no less than 8 grinders. For the most part, I'll grab whichever one that suits the task at hand. But, when working on a project that requires swapping between disc's, I'll still do that vs. having multiple grinders out. They always seem to get all tangled together and end up with only a few inches or working cord length. It only takes a couple seconds to change a disc. Usually just locking it and spinning it off by hand is all that is needed. The wire wheels seem to need a wrench, but those are loaded down more when using.

 

[ryoken]

Airgas started running this deal earlier this year. I bought two. I've got no less than 8 grinders. For the most part, I'll grab whichever one that suits the task at hand. But, when working on a project that requires swapping between disc's, I'll still do that vs. having multiple grinders out. They always seem to get all tangled together and end up with only a few inches or working cord length. It only takes a couple seconds to change a disc. Usually just locking it and spinning it off by hand is all that is needed. The wire wheels seem to need a wrench, but those are loaded down more when using.

i generally have it set up with 5" thin cuts, which are the 2 pin wrench.... big wire cup brush, adjustable..... or hand thread flap wheels.... occasionally a stone wheel...

 

[centexk5]

I don’t need these but I’m buying these.