Caliper hardware kit -question from Russia!

[kuht]

Brothers! How this detail must be stand on the front suport???????I have k5 1984 year...I need detail foto this part on support or circuit.Thanks!

http://www.lmctruck.com/icatalog/bzc/full.aspx?Page=141

WWW.LMCTRUCK.COM CALIPER hardware kit 76-91 Blazer k5 parts № 34-3670

 

[cuervo]

What is pictured in the little window #5 is four rubber type groments and a steel sliders.

If you look at the ears on the caliper you see the 4 holes. The thicker one uses the larger grommet and steel slider the smaller one just uses the small grommets. The other item in #5 window is probably a tube of grease used to grease the bolt that holds the caliper on.

If you look in window #1 you can see where they go on the caliper.

 

[4X4HIGH]

If you're wanting to know what parts are in the kit then it is the anti rattle clip for the inner brake pad, the 2 slider spacers that the caliper pin clamps down and also the 4 o-rings that the slider spacer slides in. You will need 2 kits in order to do both calipers.

 

[88jimmy4x4]

when you get your parts do one side at a time so you can look at the other to see orientation of al those damn parts...freakin puzzle. Get you some brake spring tools too, those springs are tough

 

[4X4HIGH]

when you get your parts do one side at a time so you can look at the other to see orientation of al those damn parts...freakin puzzle. Get you some brake spring tools too, those springs are tough

He is asking about parts for the FRONT DISC brakes not the rear. There are NO SPRINGS in the front.

 

[xsmokey11499x]

also for future reference... Do NOT forget to put one of the steel sliders on.. because your pedal will sink to the floor when you try to stop.
I didnt do it myself.. I swear i didnt!......