They have the # 468269 on them and they wont fit my 350/350 but look damn close except for two bolt holes.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Can you guys identify these tranny dust covers?
- Thread starter chevyfumes
- Start date
63chevyll
1/2 ton status
they are for the "K" case 700r4's, and I'm pretty sure they will fit all 4L60's
They will fit all K-case trannies.
I noticed the front cover has part of the tab cut off by the starter area.
There are 2 different covers to fit and mate different engine/tranny setups. The differences are the boss surfaces where the strut rods bolt into.
BTW, what exactly do you mean by them not fitting your 350/350 combo?
If its simply the 6 bolt holes, and your 350 only has 4 holes, then you have the non-K-case.
If its simply the 6 bolt holes, and your 350 only has 4 holes, then you have the non-K-case.
OMG! Fumes is in the Garage and he is asking a tech question! Is the world coming to a end?
If you only knew the rest of the story you'd really think the world is coming to an end.
Thanks Wes yep I don't have a K case and yep I see where someone cut off the tab on that one side I figured they probably had exaust or tranny lines in the way.
Thanks guys, now back to your regularly schedualed program.
They will fit all K-cases but may not fit your engine. Most of these covers were used in an application with a 1 piece rear main seal. The cover has a larger opening around the crank/oil pan area on the earlier pre 1986 engines with two piece rear main seal. The 4.3 V-6 applications had the top corners and bolt holes bobbed off on both sides for exhaust clearence.
dunno if the specifics mater
but my 85 350/700r4 "K" case uses the one in the back. I can't say what the front one is.
but my 85 350/700r4 "K" case uses the one in the back. I can't say what the front one is.
