CFM Industries Center Console Cupholders!

[CFMi]

Hey guys, I am working in conjunction with another company and we are going to share rights to this product, I think it's a great idea, but I wanted to get everyone's opinion on it... It's a replacement cupholder assembly for the center console in the K5's. Anyone else tired of having their drinks fall out while bouncing around the trails?? We were! These have two, taller, grippy, foam-lined holders, that are adjustable for different cup sizes! I also included a couple phone pockets in front of the cupholders too!
Let me know what you think, a good idea, or?
-Darren

 

[obijuank5]

I’ve been drawing one of my own and I decided to make them deeper instead of taller. I think it’s a good idea cause I definitely need to solve that problem too. I’m also going to have a pack out pattern to lock in those cups.

 

[76zimmer]

Good idea, what holds them in the console? 3M tape, glue, or?

 

[CFMi]

Good idea, what holds them in the console? 3M tape, glue, or?

The whole cupholder assembly gets replaced - there are tabs front and rear that lock it in place, and then when the center console door is closed, there is another tab it covers for added security.

 

[Blue85]

How about printing some nut retainers inside the front edge so optional accessories can be attached later? A few that come to mind:

• CB-mic holder pocket
• Front plate (or pocket) that holds a CB/UHF radio
• rectangular cutouts for contura switches.
• A map pocket full-width of the console

 

[warrpath4x4]

while I agree we need something, I am with @obijuank5 that deeper would be better than taller. I see a fountain cup getting smashed trying to reach over it.

 

[HankScorpio]

Can you get a Big Gulp in there?
I like my Dew by the quart.