I am about to replace bearing thru out front end...along with hubs..... i was planning on using timken bearings? any suggestions.... and also using premium hubs from warn? any other ideas...anyone has while i have this diff tore apart?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Chev 10bolt suggestions
- Thread starter KnighTs-T
- Start date
Overkill
1/2 ton status
Sounds like a good start. Use marine grease throughout and you should be good to go. marine grease repels water better.
Hossbaby50
3/4 ton status
Change the axle ujoints in the front axleshafts.
Rebel88
1/2 ton status
timken makes good bearings...a lot of companies use their bearings for install kits
Later
Later
White Knight
1/2 ton status
Just a thought.....use the 10 bolt for a door stop and shove a D60 in instead......LOL while you're there do your brakes and extend the breather tube up as high as possiible. If you have the cross over tube with hollow ends...dump it and get a thick solid one.
White Knight
White Knight
TrcksR4ME
1/2 ton status
I would use synthetic grease, 3x's as much but definately an advantage over regular or Marine grease.
