Chevy 383 Stroker

[mdevlin]

I am parting out my 1984 Blazer. It's a project that I finally decided I just don't have the time or the money to finish, so I am parting it out.

I am selling the Chevy 383 Stroker engine that I rebuilt. (complete rebuild, bored .60 over, hot tanked, brand new everything.

Here is a fairly complete parts list:
Chevy Vortec Heads
Comp Cams Roller Tipped Rockers
Comp Cams camshaft (not too aggressive profile)
Keith Black Hypereutectic Pistons
383 Stroker kit with the pistons, connecting rods, and a chevy 400 camshaft
MSD Billet Distributor
MSD ignition controller
MSD Spark Plug Wires
Edelbrock Water Pump
Pete Jackson gear drive set
Holley Mechanical Fuel Pump
K&N Air Filter
Edelbrock Carbuerator
Performer Vortec Intake
Oversized Oil Pan (8 quart capacity without filter)
200 Amp Distributor
Various Stainless Steel pulleys, including a Power Steering kit from March

Since most of the pieces are virtually brand new, I am looking to get $3000 for the whole setup, which is a real good deal, but make me an offer. I'll consider anything.

Also, if your interesting in just certain parts, I am willing to break up the package and sell everything individually.

Please PM me with any questions, or call me at 617-413-8739

to check out the whole truck setup, go to: http://aisle10.net/theblazer/

Make an offer on anything you see

 

[adamforsythe]

How much do you want for the pullys

 

[mdevlin]

pulleys

The pulley setup is for a non-A/C engine. I believe all of them are stainless steel except for the power steering pulley/bracket, which are aluminum. All of them are Mr. Gasket pulleys, the power steering setup is from March Performance.

I'll sell you the crank pulley, water pump pulley, and power steering pulley, plus all brackets for $150.

Tell me what you think...

 

[adamforsythe]

pm sent
Thanks
adam

 

[84CUCV]

Send me a PM. i Would like some stuff. mike