Corbeau seat install?

[rgretzinger]

So I got the front seats today and I went to install them and it seems like my holes don't match up. I have dynomat on the floors and only have the holes from the previous seats drilled. Does anyone have a picture of their floor with bolt holes so I can punch a hole through the dynomat. This is a 74 K5. I was told that these were bolt in and I bought the adapters so I am guessing I just haven't punched the holes through the dynomat. Thanks for the help.

 

[bot0611]

PICS damn it!!!...

What seat did you had before theese ones??

 

[rgretzinger]

Pics would help me. If the seats are true bolt ins and don't require modification to the adapter brackets then pics of installed front seats would tell me where the bolt holes are under the dynomat. I could post a pic but it would just be of a carpeted and dynomated floor.

 

[rgretzinger]

Not sure if the ones in it were original or not but looked really old.

 

[rgretzinger]

Driver's seat bolts up fine for the exception of the outside rear bolt is about 2-3 inches off . The passenger side was a flip up so I think it only bolted in at 3 places. Rear outside bolt isn't drilled I think. Any one know?

 

[doubletrouble]

Have looked from the underneath side of the floor? The holes go all the way threw, so you should be able to see them and punch your hole from underneath.

 

[rgretzinger]

Yeah I did that last night. I think I am going to have to fab a bracket for the passanger seat. Man it chaps my hide when things are "bolt in" and then you have to break out the welder.