What's new
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.

Cross over steering 44

L

Lilchubby

Registered Member
Joined
Jul 26, 2013
Posts
44
Reaction score
0
Location
Colorado Springs
I have a full set or pieces to build crossover for your danna 44. A flat top knuckle, just needs to be drilled and tapped. Studs and cone's with nuts. Both tie rod ends, they are the HD ones, Like ORD sells. Jam nuts with weld in bungs. It also comes with the pitman arm, for a 2wd gear box. $200 for the X over. Price includes shipping. I have paypal, and can also being them with me to the bash. Thanks Mike

steering 001.JPG
 
Last edited:
I have a piece of DOM to add to this. All you need is the steering block. $200 shipped. $25 for the knuckle.
 
I would love to have this but I am uncertain if it will fit a 10 bolt??

I have read some parts will interchange from a 44 to a 10 bolt but I'm not sure about the knuckles etc.
 
shoot me a pm with where to mail payment. also any way i can get the brackets/straps for the front bushings on the sway bar ?
 
Correct me if I am wrong, but you would need both dana 44 or 10 bolt knuckles. But you can't mix-match.
 
I don't see how it would matter if you had a 44 on one side and a 10 bolt on the other. I used ball joints for a 10 bolt in my 44 and they fit, they fit the knuckle and the housing. I don't see any problems using this knuckle.
 
The tierod sits under the knuckle on the 10 bolt, and the 44 sits on top. You could use it, would just have to drill the tierod hole out, and use a taper sleeve to correct it.
 
you can drill the d44 knuckle for a tapered bushing so it will work with a 10 bolt knuckle...link


Graphic1%20(3)%20(10)%20300x225.jpg
 
You must log in or register to reply here.

Latest Posts

Top Bottom