crossover steering....meed some help

[rob h]

should be...need some help...I have skys pitman, draglink and the tierod end to connect em....my question is my arm (a no name..)that bolts to the 60 has 3/4 holes in it, they arent tapered...what would i use that has 7/8-18 left hand threads that would work with the 3/4 hole.. do i need a heim or what could i do with it...any ideas....? all the parts should work good..if i could figure what to do..

 

[rob h]

anyone know where to get a heim joint rod end with 7/8 18 lh threads..?.............just picked up a reamer for the taper then will use the end es2010L ......

 

[wayne]

It's been a while since I had mine off but IIRC you might not be able to ream out the hole because it might be to big then. I don't think mine is 3/4" on the bottom. Check it with the TRE before you start reaming it. I could be totally wrong though. The reason I stated it is years ago when I got my Sky arm I got one shipped that had a straight hole with no taper, I believe the hole was 3/4" and couldn't be tapered. Sky sent me a new arm.

 

[rob h]

went to my friends shop with the arm and a tre and he made me a insert that pressed in both holes with the tie rod taper...all fixed..