I need a pair of front Dana 60 bearing hubs for an 84ish SRW Chevy D60.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
D60 bearing hubs
- Thread starter AKbigsub
- Start date
ttt
50 views and no responses. Bummer!
Some of us read every post... but can't help.
i got a pair .
being used for mockup on truck at moment .
and shipping to you be a killer from new york state .
otherwise you be first in line for the deal brother.
also i remember the old thread and i checked my current set on this early run dana 60 and it has full time drive slugs . i pulled the caps and found the grove packed full of dirty old grease . almost looked like it wasnt there.
being used for mockup on truck at moment .
and shipping to you be a killer from new york state .
otherwise you be first in line for the deal brother.
also i remember the old thread and i checked my current set on this early run dana 60 and it has full time drive slugs . i pulled the caps and found the grove packed full of dirty old grease . almost looked like it wasnt there.
i got a pair .
being used for mockup on truck at moment .
and shipping to you be a killer from new york state .
otherwise you be first in line for the deal brother.
also i remember the old thread and i checked my current set on this early run dana 60 and it has full time drive slugs . i pulled the caps and found the grove packed full of dirty old grease . almost looked like it wasnt there.
I do not need the rotors (I don't even know if they are on there) and wonder if one hub would fit in a USPS flat-rate box? I sent about 60 pounds of tools to my son in Vegas and it was only like $14. I did "double box" it because those flat-rate boxes are not very sturdy. I would gladly pay the postage on two of these flat-rate boxes.
tell you that it wont fit in a flat rate minus hub . still to fat.
on a side note I did find the axle is totally junk now. sitting upside down I seen a 6-7" long weld line from the cover to almost the step up in the middle of the pinion bearing section and off to the side a huge hole welded shut.
I would never trust this housing to wear gears good again . so when I am done with mockup it will get parted and scrapped.
on a side note I did find the axle is totally junk now. sitting upside down I seen a 6-7" long weld line from the cover to almost the step up in the middle of the pinion bearing section and off to the side a huge hole welded shut.
I would never trust this housing to wear gears good again . so when I am done with mockup it will get parted and scrapped.
Bummer on your housing being junk. I will keep looking for some hubs, but if you would drop me a line when your mockup is complete I would be greatful.
I got few sets of drw . could check on machining down to srw for ya 
. boss's dad has machine shop .
. boss's dad has machine shop .
Still looking.
