Discussion in 'The Garage' started by broc944, May 7, 2006.
What is the minimum rotor thickness to have the rotors turned?
when you pull the rotor its stamped right on it
I knew that, really I did. I was just testing ya .
Sure ya where...
Btw the numebr your looking for is 1.465"
IMO they are good down to around 1.25" - that's the thickness of the Dodge rotor, using the same caliper.
Speaking of which. I've seen photos of the Dodge rotor and the rotor looks like chevy 3/4 ton rotor. Are the rotors the same?
Separate names with a comma.