dana 60 width

[cegusman]

What is the width of a srw dana 60 from hub to hub?

 

[mikey_d05]

WMS to WMS?

Chevy: 69.5"
Ford: 69.25"
Dodge: 67.5"

Hope that's what you were looking for.

 

[nvrenuf]

Since the question has been answered...

How about dually width?

 

[sandawgk5]

Since the question has been answered...

How about dually width?

About 77.5" WMS-WMS for GM

Dik

 

[mikey_d05]

IIRC Dodge duallies are 75.5" as well.

 

[cegusman]

Whats WMS? Wheel mating surface? If so I need the width for the outside edge of the locking hub to locking hub?

 

[mikey_d05]

Wheel mounting surface.

Is your truck near? Can you measure how much the locking hubs stick out from the wheels? That'd give you a pretty good idea.

I'd do it for ya but my rig is 30 miles away.

 

[cegusman]

Mines at home and we are try to arrange a trailer to use. But need the dimensions now not later. I know my locking hubs stick out about 1/2"

 

[mikey_d05]

Ok, sorry to ask more questions without giving you the answer you need...but what might be the issue with the trailer? Your hubs should be inside the widest portion of the tire. I drive over my fenders to get my junk on my trailer.

 

[sandawgk5]

My locking hubs stick out about 1.5" so that with DRW width of 77.5 would give you ~80.5" lock to lock.

Dik

 

[cegusman]

Trying to see how wide the trailer needs to be. not sure if it has side or not.

 

[mikey_d05]

I'm gonna go ahead and guess that your tires are going to get into the sides if it does. What are the specs on your tires and rims, I could give you a guesstimate outside to outside measurement if I knew those. SRW?

 

[cegusman]

38.5 sx's on 15-9 wheels 4.25" back spacing

 

[4x4_76]

81.5" is pretty close number, just measured.

 

[mikey_d05]

My educated guess says that you're roughly 83.5" outside of sidewall to outside of sidewall. Mind you, that depends a lot on if your tire's section width is right at spec with pressure in them or not.