there is an adjustment tab on top of the box that may help with that.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Defrost not working
- Thread starter rampage
- Start date
rampage
3/4 ton status
Fixed! 
There was a kinked vacuum line behind the carb.
There was a kinked vacuum line behind the carb.
rampage
3/4 ton status
In anticipation of having to replace that white plastic clip I had my friend order one ahead of time. So to do some preventative maintenance I’m going to go ahead and replace it. Like I said, been a while since I replaced mine. Do you just unbolt it, remove the pin holding the linkage and it slides out? Any chance of the linkage falling back down behind the diverted door?
IIRC the linkage will stay put, plastic piece is screwed onto door and pined to linkage
my solution
rampage
3/4 ton status
I did something similar to mine since I didn’t want to wait to order one. I’ve seen someone selling billet aluminum ones for $15 now.
I don’t have my friend’s truck here right now so I was unsure. Does the old one just slide out of the slot it’s in without removing anything else besides the screw and pin?
yep has a tab on none screw end, tilt it remove install
rampage
3/4 ton status
rampage
3/4 ton status
Link to aluminum clip I was referring to.
https://www.amazon.com/Conditioning...lpcontext&ref_=fplfs&psc=1&smid=AYFC9U2WFNCFC
https://www.amazon.com/Conditioning...lpcontext&ref_=fplfs&psc=1&smid=AYFC9U2WFNCFC
rampage
3/4 ton status
Not really, needs to extend out to where it’s originally screwed to for strength like Wes did. Easier to bend two piece of metal at 90*, one on either side of the linkage, and screw those metal pieces to the door. I think I made mine out of a piece of small square tubing with a bend for the tab. But for $15 I’d just get the one I posted and never worry again.
