deleted
Last edited:
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
deleted
- Thread starter kennyw
- Start date
I'll have to double check the condition, I haven't looked that closely at the impact strip yet.
lak2004
1/2 ton status
How much for the gauge cluster?
I'd take $35 for it. It is only good for 1990-91 though since it uses the electrical speedo rather than mechanical.
SUBFAN
1/2 ton status
How solid are the barn doors, and the strip of the rear quarters (x2) behind the tire, say about the upper trim line back?
How the heck would we get it to 52802?
How the heck would we get it to 52802?
You don't know what your missing. No rust to speak of anywhere on this rig. I did find a small spot of surface rust where the paint has flaked off on the lower rear quarter. Nothing on the barn doors for rust. No dents either.As far as getting them to you its possible, just not going to be cheap
I'd expect it to run $150+ to ship.
dead links to pics removed.
Last edited:
Pics are posted of the impact strip.
ttt
adamforsythe
1/2 ton status
Hows the TBI set up running? How much for it. (Throttle body, computer, harness, etc.)
Its running much better now that I replaced the throttle body to intake gasket. It had a very bad surge before that. The motor still has a slight miss that I have not had the time to diagnose. But it is not setting any codes.
I am asking $150 plus shipping for the complete setup with wiring, intake, distributor, computer, sensors, ect.
Another note... I have to delay parting this rig out for a couple weeks since I just found out my other truck's rebuilt tranny has to be redone. I need to keep this rig up and running until I get the other one back.
I am asking $150 plus shipping for the complete setup with wiring, intake, distributor, computer, sensors, ect.
Another note... I have to delay parting this rig out for a couple weeks since I just found out my other truck's rebuilt tranny has to be redone. I need to keep this rig up and running until I get the other one back.
adamforsythe
1/2 ton status
How much for the overhead and center consoles when you're ready to part?
I'd take $10 for the center console and $75 for the overhead console.
PM sent.
425 Xpedition
1/2 ton status
Will you ship the dash pad?
I'd say $50 plus shipping.
Yes I can ship. It won't be cheap due to the odd size.
