DIY Bedliner.... Again

[Fingerless]

Ok so I searched. I understand what im doing but have another question. If I sand Blast the entire inside. But don't bring it completely down to bare metal would that work over hand sand scuffing?

Or if i do get some bare spots hit them with some primer again?

 

[ryoken]

why would you bother sandblasting if raw steel wasn't your goal? on that note, there really isn't an in between with blasting so much, paint is there, or it's gone...

 

[Fingerless]

Well I had a few spots I was going to work on and figured why not do the whole thing while im at it. So Will I still need to rescuff the primer if I take it down to bare and reprimer it?

 

[ryoken]

yup... wet on wet is always possible and sometimes a good route, sometimes.. but..... if your blasting and priming, scuffing the primer is a VERY minor step.... doesn't take much at all to run over a primered floor with a maroon scuffpad...

 

[Fingerless]

Sounds good. Well my HF 20lb Pressure Sand blaster should be here friday so well see!!!