Kert is the man! He recently started making driveshafts, and i called up and ordered up this 1350 CV slip yoke dshaft for my k5. I just got it today, and its BEEF. Looks freakin great i cannot wait to put it on! Thanks again kert!
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Diy4x Rocks
- Thread starter stockk5
- Start date
look the beef is already on the table!
dfl701
1/2 ton status
wow that looks great!
Whats the danger sticker all about?
shaun89
1/2 ton status
it says i have to securely bolt down both ends of the driveshaft otherwise ill be sucked into it and twirled around like the poor man in the picture. 
woooopsss i was logged in on my brothers name. haha
Kert is the man! He recently started making driveshafts, and i called up and ordered up this 1350 CV slip yoke dshaft for my k5. I just got it today, and its BEEF. Looks freakin great i cannot wait to put it on! Thanks again kert!
Thanks for the compliments bud!! Let me know how it goes together for you.
How did the box fare in transit? I see alot of paint missing in cardboard abrasion fashion.
hahaha where do you even get a danger sticker with a guy twirled up in a drive shaft? Beefy looking shaft by the wayit says i have to securely bolt down both ends of the driveshaft otherwise ill be sucked into it and twirled around like the poor man in the picture.
cegusman
3/4 ton status
Whats something like that cost?
blazerboss 85
Banned
x2 i had mine made at the local driveshaft place for like 350 i think .i dont quite remember how much but mine was like 8 inches longer than an np208 0r 241 shaft not that it matters
Kenny78
1/2 ton status
Blazerboss, did yours have a 1350 cv?
blazerboss 85
Banned
yes sir it does
ill be able to give a full review in a week or so once i get some angle shims!
sparkey83
1/2 ton status
x2. i have been looking for a heavier rear shaft for my blazer
PM Kert aka cybrfire
edit: never mind need to be a paying member to PM
Drive shafts is a new line for us. I'd rather not start spouting out a bunch of prices but rather quote on a case by case. We've done half dozen or so now. So far all working good and customers are happy.
Call me at the shop if you like to get a quote. PM's get a little crazy at times and I'd like to get you down on paper with all the correct measurements and ujoint sizes and so on.
Call me at the shop if you like to get a quote. PM's get a little crazy at times and I'd like to get you down on paper with all the correct measurements and ujoint sizes and so on.
