does anyone know who makes this lift?

[84gmcjimmy]

[ QUOTE ]
Roll bar? It ain't gonna roll, it'll just flop on the side.

[/ QUOTE ]

Haha your right, just flop!

 

[roadhawg]

I'd venture to say you could cross any lake in new mexico in that bad boy and never even get the carpet wet! And as for the 40,000 dollars that must be including all the crack he was smoking to build something that scary in the first place! /forums/images/graemlins/histerical.gif /forums/images/graemlins/histerical.gif /forums/images/graemlins/histerical.gif

 

[kombi59]

what a f---ing tard!!! gotta wonder WTF!!! /forums/images/graemlins/dunno.gif /forums/images/graemlins/hack.gif

 

[beater_k20]

In a message dated 4/11/2004 7:09:49 PM Pacific Daylight Time, Beater_K20 writes:
where did you spend $40K on that truck?
his response....

Over 20 years, 3 motors, 4 lifts, 5 sets of tires, 4 transmissions, rears, most of all, if we were to count our time (hours). of course this is not a $40,000 dollar truck. We have the reserve set at $3,500. Thanks for looking.

 

[jackedjimmy350]

wonder why he chose the "cut out" flares?

 

[jrsheets]

WATCH OUT!!! theres a speed bump ahead
Guess you call that a frame lift eh?

 

[gm4x]

[ QUOTE ]
i cant seem tto find any place that sells it.
flexy

check out the rear pinion angle. /forums/images/graemlins/yikes.gif

[/ QUOTE ]

GEESE-O-PETE!! I bet he drilled a little squirt hole in the top of the housing.....he stops every 5 miles or so & lubes the pinion bearing /forums/images/graemlins/dunno.gif Wonder how much of his $40,000 was welding rod? I got a nose-bleed just lookin' at it /forums/images/graemlins/rotfl.gif