Is there anything preventing me from running a 203 range box with a 32 spline input and a 31 spline (F*rd) output into a Chevy 205 with a F*rd 31 spline input gear?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Doubler Question
- Thread starter Hogback Fabrication
- Start date
nope, nothing wrong with that. thats what i was going to run, but now i found something else
ford 31spline input is the cheap alternative to the expensive chevy 32spline input
ford 31spline input is the cheap alternative to the expensive chevy 32spline input
SCOOBYDANNN
1/2 ton status
AFAIK the doubler shaft only comes in a 32 spline. So the Chevy would have to be 32. so yes i think there would be a problem.
Thanks. Any significant strength differences between the 31 and 32 spline stuff?
SCOOBYDANNN said:
Most companies that make doublers (if not all) have at least 31 and 32 spline intermediate shafts.
SCOOBYDANNN said:
from northwestfab's website:
On top of our basic kit you will need:
- 1 NP203 to mate to your transmission
- 1 NP205 with either a short 32 spline or 31 spline input gear, or a Dana 300.
- A 2nd crossmember or custom crossmember
- A means to shift each transfer case from high to low range.
- Modify your driveshafts to fit new driveline length.
noob
SCOOBYDANNN
1/2 ton status
my bad---ill crawl back in my hole now
SCOOBYDANNN said:
come on dan, its alright
