Drain Coolant From 6.2 Block???

[uglytruk]

I'm putting a new rad in my 6.2 Blazer, and want to drain the Prestone I've been diluting because of a rad leak. I removed the drivers side block heater, but don't see a block-drain plug on the pass side. Only a frost plug that I'd rather not remove.
My SB Chev's always had a 1/2" plug. Am I missing something? Don't tell me it's behind the starter!
Or maybe I'll have to do with re-installing a wing-nut frost plug, and fill and flush a couple times, and be satisfied with whatever ends up on the pass side...

 

[uglytruk]

Here's the block, hole where heater goes, and starter side w/o drain plug, and the cutie who show'd me to the dressing room for an xray

 

[4x4_76]

If I'm not mistaken, drain plugs are behind the motor mounts

I go and take a look...

 

[uglytruk]

My pass mount is toast, so time ta change it! and Drain coolant...

 

[4x4_76]

Yep, it's behind the mount bracket. You can see it if you look closely from the starter to the back of the bracket. What a stupid place for a coolant drain

 

[uglytruk]

If you look at my toasted engine mount, pix taken looking to the rear, you'll see it's TIME FOR A CHANGE!!!

$26 locally, $18 + free SH from California, same ANCHOR brand

 

[uglytruk]

Yup, buried!