Hey guys, i just put my dana 60 in my k5 with 350/700r/208. My driveshaft is to long to bolt up by like 1" it seems. I know its gotta be shortened but how should i do it? and how do i measure properly for suspension droop and such? thanks guys!
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Driveshaft problems...
- Thread starter stockk5
- Start date
Randy92782
1 ton status
which driveshaft (front or rear) and who's gonna shorten it. if you're egtting it done the guy should know. if you're doing it yourself i think i went bout less than half the splines on the shaft itself. if it's rear there's a good chance it's sliding into the t-case right??
if so i'd go more than halfway in. just slightly more though. just my opinion
if so i'd go more than halfway in. just slightly more though. just my opinion
sorry.. i assumed most thot front. Yes its a dana 60 front, and i guess deciding if ill do it myself or not is a matter of cost...
