Sold Driveshafts

[mechted]

~4 year old driveshafts for sale
Front: GM 3R flange to 1310 series. 28.5" to 31.5" length. CV was fully rebuild and has had some minor grinding for increased angle. Tube, slip and yoke replaced with new parts. Minor rub occurred against exhaust tube, but just scratched some paint. Never bashed on any rocks. All joints are in near new condition. $200 + shipping. SALE PENDING

Rear: 1350 to 1350 series. 38" to 41" length. Fully new shaft 4 years old. Never bashed on rocks. Both joints are in near new condition. $150 + shipping. SALE PENDING

 

[firemedicsafd]

Can you tell me what set up you had them in? i currently have a slip yoke 208, but Will install a SYE 241 to 14 bolt in the rear and dana 60 up front. Thank you!

 

[mechted]

It was on a K5 with th400/np205 combo going to Dana 60 and 14 bolt FF axles on about 4.5 inches of lift. Both front and rear axles pushed out 1" which basically kept the wheelbase at stock 106.5. Was pretty much at max recommended angle on the rear shaft.

 

[firemedicsafd]

ill check my current measurements and see if yours will work for me. Thank you

 

[cwn anwyn]

Still got these or did firemedic get them?

 

[mechted]

Still available

 

[MetalMulishaMarcus]

Wish i had the money for these. I wonder what shipping would be for both.

 

[mechted]

These are sold.