CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Engine cross member...
- Thread starter dangerdog
- Start date
What engine? Likely the pan.
what engine ? and crossmember ? small block or big block .
how do the mounts look ?
stock 30-40 year old ?
stock import replacement that dont last about a year ?
aftermarket beefy units ?
how do the mounts look ?
stock 30-40 year old ?
stock import replacement that dont last about a year ?
aftermarket beefy units ?
Sure the engine brackets are the 4x4 specific ones ?..they are taller by an inch or so than most used on 2wd trucks and cars ..
I assume we're discussing a square body 4x4 ?..between 73-87..
I assume we're discussing a square body 4x4 ?..between 73-87..
Make sure you get the taller 4x4 mounts
and most newer replacement rubber frame side mounts are basicly junk out of the box .
lots of guys have reported few trail rides or 6months or so of dd use there shot again .
do energy suspension replacements or ord or diy4x style .
lots of guys have reported few trail rides or 6months or so of dd use there shot again .
do energy suspension replacements or ord or diy4x style .
Straight sixes used specific engine brackets,that far as I know wont bolt up to a V8 or be anywhere near right if they would..
A V-6 like a 4.3 might bolt up to a V8,I have no clue if they are the same as what a square body 4x4 V8 would be..
A V-6 like a 4.3 might bolt up to a V8,I have no clue if they are the same as what a square body 4x4 V8 would be..
I really don't remember. The truck originally had a 250 six. Probably found some v-8 mounts somewhere. I have had the truck for thirty years and did the motor swap some 20 years ago. Damb how time flies!
