Exhaust routing issue

[BoondocK5]

I've got some routing issues on my Blazer.
I need to route the down pipe on the left side of the engine down and forward under the oil pan then a hard rearward turn to meet up with the other down pipe to run rearward on the right side of the vehicle.
i've seen it done on Motorhomes, but never on a truck.
The question is, does any company out there manufacture a prefab kit to do this from a stock manifold? I have looked high and low with no dice.
Anybody know anything I don't about this?

 

[lectric80]

There are a couple I have seen on this site, although nothing that I am aware of being prefabbed. Most run the right side bank across the front then back down the left side, since our trucks have passenger drop this gives the most clearance.

Don't be afraid of the Master Muffler there on 33rd not far from you. They do really good work at a reasonable price, and could probably make what you need. Although they would probably need the truck to get it right.

 

[BoondocK5]

There are a couple I have seen on this site, although nothing that I am aware of being prefabbed. Most run the right side bank across the front then back down the left side, since our trucks have passenger drop this gives the most clearance.

Don't be afraid of the Master Muffler there on 33rd not far from you. They do really good work at a reasonable price, and could probably make what you need. Although they would probably need the truck to get it right.

Down on State street?

I should just do this myself, I have that nice Hobart Mig sitting in the garage, and just about every tool known to man out there too, I just hate custom exhaust work.

 

[4X4HIGH]

Down on State street?

I should just do this myself, I have that nice Hobart Mig sitting in the garage, and just about every tool known to man out there too, I just hate custom exhaust work.

So have your local shop bend up and fit the pipe then you take it home and weld it up yourself.

 

[lectric80]

Down on State street?

I should just do this myself, I have that nice Hobart Mig sitting in the garage, and just about every tool known to man out there too, I just hate custom exhaust work.

No further west on 33rd South. It is a shop I have used a lot and they do very good custom work, including mandrel bends. It is really not all that far from your house.

Edit: Yeah, 35th on that side of 215. They are about 6-8 blocks west of Bangerter.

 

[BoondocK5]

I will go see, thanks!