Well i have a problem.. I have headers, ran just headers to 2 flowmaster 40's and dumped out before my rear axle. Now i just added a traction bar on my truck so i have to go back to a single exhaust on one side. However i cant do the typical Y pipe from factory due to lift, and all that, so far i have had passanger side go out behind tcase take a 90degree turn towards the other and then another 90 piece i welded into the exhaust on driver side. However its all mostly flex pipe due to crazy cost of bent tubing/shop cost. Can any of you guys give me some ideas with what you did? Pictures are always best, my exhaust isnt set in stone.. just bolted on no welds yet.. so i need ideas before welding! Any headers to single exhaust if ya have em! thanks guys
