fender cut

[bowtieboy4life2000]

i cut my fenders today. i have 33's on and no sway bar and my tires rub not no more. i put my friends 37's on and had plenty of room for bigger tires

 

[Dafey]

What no pics??

 

[NorCalKid]

I dont know what you are talking about, I see pictures.

If I were you I would cut the bottom of the front off as high as you can with out chopping the inner

 

[Dafey]

I swear there wew no pics before

 

[blowedupmotor87]

Looks good! I'm gonna be doing that to mine soon too! How much lift do you have, 4"?

 

[bowtieboy4life2000]

4 inch i may go higher but ass long as i can get 37-40 inch tires on i don't care

 

[Hogback Fabrication]

37's on a 4" lift fit without too much trimming.

Its really when you get to 40"+ tires that you have to ditch the inner fenders, move the front axle forward, cut a ton more, etc. to get the tires to fit without lifting the truck a mile in the air.

 

[bowtieboy4life2000]

i almost left my inner fenders then i decided to put them back on cause it is my DD and it rains and snows quiet abit

 

[thebird00]

I just cut mine more this weekend. I used yunit's diagram. I was able to bolt the inner fender back in with the front and rear bolts. With a little hammering I think it'll work pretty good.

 

[AJMBLAZER]

I just cut mine more this weekend. I used yunit's diagram. I was able to bolt the inner fender back in with the front and rear bolts. With a little hammering I think it'll work pretty good.

Got a link to this diagram?

 

[k2mslskier]

I think these are the one's you are referring to.

 

[blazin_blazer]

you have any pics?

I just cut mine more this weekend. I used yunit's diagram. I was able to bolt the inner fender back in with the front and rear bolts. With a little hammering I think it'll work pretty good.

i like the look but need to keep my inners, you have a pic w/this cut and inners installed?

 

[thebird00]

i like the look but need to keep my inners, you have a pic w/this cut and inners installed?

I'll snap one tonight but I doubt I'll be able to upload it until tomorrow. Right now the whole inner fender is in. I'm gonna see if I want to trim some off the gede and then try to put some more bolts in it.

 

[thebird00]

Got a link to this diagram?

Here's the link AJM. Its the same as the pics that were posted but this may be easier to print if you need to.

http://www.keystonekrawlers.com/Mods...5wheelwell.htm

 

[AJMBLAZER]

Cool, thanks man.

 

[thebird00]

Ok here's the front driver's side. I tried to get a close up so u can see then inner fender in there.

 

[thebird00]

Here's the rear. If I could go back, I would round the corners a little differently to block that inner seam.