Flat Top Source?

[CHEVY 4WD]

Im in need of a set of flat tops for my 10Bolt PRETTY bad everytime I almost have a set somthing happens and the deal dosent fall threw. Anyone know of a good source for these? I would prefer to buy them already machined but at this point I cant be picky

 

[MTBLAZER89]

http://cgi.ebay.com/ebaymotors/Dana-44-Chevy-flat-top-steering-knuckles-Chevrolet-4X4_W0QQcmdZViewItemQQcategoryZ33728QQitemZ8045928780QQrdZ1


http://cgi.ebay.com/ebaymotors/Dana-44-Flat-Top-Knuckles-not-Dana-60_W0QQcmdZViewItemQQcategoryZ33728QQitemZ8046943406QQrdZ1

http://cgi.ebay.com/ebaymotors/Dana-44-Flat-Top-knuckles-Jeep-Crossover-steering-4x4_W0QQcmdZViewItemQQcategoryZ33728QQitemZ8047051520QQrdZ1

I think Sky and ORD carry them sometimes too. Have you hit up the yards? I got mine from a grand wagoneer. They are an often overlooked source.

 

[AZ79K5Project]

I got mine from a local pull your own parts place. $60.00/pr. Most 4x4 places that know what they are doing can machine them. ORD also machines them for $70.00 which is a LOT cheaper than a local quote for me in Phoenix.

The Dana 44 are a dime a dozen. I was lucky because someone already pulled both axle shafts when I found mine sitting at the end of an empty axle tube.

 

[Muddytazz]

email me since you can't pm at [email protected] i have some

 

[MTMike]

WFO Concepts sells them

New cast knuckles:
http://wfoconcepts.com/Steering/Dana44/nc_flattop.html

Used when available
http://wfoconcepts.com/Steering/Dana44/UsedFlattop.html