oneofthefewbmx
1/2 ton status
I have been collecting parts to do a ford hub conversion on my dodge similiar to this thread:
http://www.dieseltruckresource.com/dev/junkyard-hub-conversion-t287434.html
I changed my mind on the conversion and I am looking to sell the parts I collected. They are as follows:
Ford Dana 60 parts;
Stub shafts x2
Spindles x2 (with spindle nuts)
Hubs x2 (with decent used bearings)
Lockouts 2 SETS (manual set, and auto set...wasnt sure which I was going to use)
This should be everything you would need to do a "spindle-out" conversion on a 2nd Gen Dodge to have free-spinning hubs and lockouts.
I will take $500 bucks for the whole kit. Plus shipping (about 90 bucks) or you can pick them up from Temple, TX and save the shipping.
I will post up some pics tomrrow when I get off work.
PM call / text 254-220-68O5
http://www.dieseltruckresource.com/dev/junkyard-hub-conversion-t287434.html
I changed my mind on the conversion and I am looking to sell the parts I collected. They are as follows:
Ford Dana 60 parts;
Stub shafts x2
Spindles x2 (with spindle nuts)
Hubs x2 (with decent used bearings)
Lockouts 2 SETS (manual set, and auto set...wasnt sure which I was going to use)
This should be everything you would need to do a "spindle-out" conversion on a 2nd Gen Dodge to have free-spinning hubs and lockouts.
I will take $500 bucks for the whole kit. Plus shipping (about 90 bucks) or you can pick them up from Temple, TX and save the shipping.
I will post up some pics tomrrow when I get off work.
PM call / text 254-220-68O5
Last edited:
