Indy4x4Fab
1/2 ton status
found
Last edited:
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
found
- Thread starter Indy4x4Fab
- Start date
I am guessing he can work with a truck harness?
the difference is in the rear light, the wires will need shortening.
Or does he just need the engine side harness with the guages?
I should have one or 2 wiring harnesses and one guage set for the 6.2 trucks.
Indy4x4Fab
1/2 ton status
we only need the fuse block all the inside wiring harness and just the engine side of the exsternal wiring harness, tail lights and head light wiring harness we can make do with what we have on the truck.
OK I will work on that, I have a pile of wiring harnesses that I need to sort out and find which ones are the diesel ones.
And you said you need the guage cluster too right?
Indy4x4Fab
1/2 ton status
yes need the gauges too and colum, but if u dont have the colum then i just need to know about what year u think the wiring harness is.
I have the column but not sure if you want manual or auto.
The ones I have are 83 manual tilt, and an 88 auto non-tilt.
I have a complete interior wiring harness from an '83 Chevy 6.2L pickup. I also have the diesel dash bezel from that truck as well (dash mounted wiper switch opening). I have already sold the engine harness and guage cluster though.
I also have a glow plug wiring harness left over from my '79 K10 that I swapped a 6.2L into with manual glow plugs. That truck I was able to keep the original engine harness by just extending the HEI ign wire to reach the IP at the front of the engine since all of the sending units were in the same place as the original 350.
I also have a glow plug wiring harness left over from my '79 K10 that I swapped a 6.2L into with manual glow plugs. That truck I was able to keep the original engine harness by just extending the HEI ign wire to reach the IP at the front of the engine since all of the sending units were in the same place as the original 350.
Indy4x4Fab
1/2 ton status
kenny and iceman
iceman we will take the 83 manual tilt and the wiring harness that goes with it. if u dont have the gauge bezel, kenny we'll take the gauge bezel off ur hands. can u get me a couple picks to ur email address [email protected] we would appeate it, thanks guys.
iceman we will take the 83 manual tilt and the wiring harness that goes with it. if u dont have the gauge bezel, kenny we'll take the gauge bezel off ur hands. can u get me a couple picks to ur email address [email protected] we would appeate it, thanks guys.
I do have all of it.
I have the harness, the column, and the guages.
I will round them all up, get you some pics, and a price.
I am asking $20 plus shipping...
Indy4x4Fab
1/2 ton status
pm sent to kenny
Indy4x4Fab
1/2 ton status
still in need of this
Indy4x4Fab
1/2 ton status
bump
Here are some pics:
guages then wiring fuse block/inside wiring then the headlight/engine compartment wiring.
