Free Regulator for MIG setup

[rdn2blazer]

I got this regulator when I bought my Miller 180 autoset welder a few years ago. It was used for all of five minutes. It's still brand new. I just didn't like the fact the adjustment handle is a blade screw vs a "T" type handle. It could probably be swapped out, I just went back to my old regulator that worked fine. Hat it's new and free. Not worth selling. I would rather give it a a fellow CK5er for free.

 

[tRustyK5]

For what it's worth, my regulator is the same way. In some ways I like it better as hanging my helmet on the reg's won't accidentally "re-adjust" my flow settings...

 

[ryoken]

hmmm, my 180 AS came with a T handle one...

 

[blazinzuk]

I will take it sir.

I was welding outside the other day and opened a car door right into my current regulator broke both gauges out of it. Well broke the plastic and bent the needles

 

[rdn2blazer]

I will take it sir.

I was welding outside the other day and opened a car door right into my current regulator broke both gauges out of it. Well broke the plastic and bent the needles

It's yours, you have a PM.