Front Driveshaft from 77 Blazer

[mtnman210]

Drive shaft that came out of a 77 blazer with a 4" lift. Bolted to a dana 44 and 203 tcase. It's roughly 29.5" collapsed and 32.5" extended to where just the splines show. Ujoint at the axle end is missing caps, CV seems tighter than normal but seems to be working fine.

$50 would prefer not to ship
located in Northridge, Ca

 

[blazin_blazer]

if you decide to ship let me know..thanks

 

[mtnman210]

I can check on a price, where to ?

 

[mtnman210]

I just realized I measured the wrong shaft.

THE CORRECT MEASUREMENTS FOR THIS SHAFT(I updated the first post as well)

~29.5" compressed
~32.5 Extended

 

[blazin_blazer]

i'm not sure what your original measurements were, but i think i can still use this. i still want it anyway...my zip is 72143 ..tia