Does anyone know if there is any T-cases that I can oull an out putt flange that I can pull from a junk truck. I know that some yotas and ford had flanges for the outputs either on the front or the rear of the trnsfer cases I have an NP203 and has a yoke on the rear and my measurements for the rear are dam close to the front drive shaft and I was going to make up multiple shafts so that they are interchangeable and it will cut back on space being hogged up but large shafts laying around in the truck I'm sure that ya will agree. The output is 32 spline shaft I found that the driveshaftsuperstore sell them but there like 80 buck and I'm trying to not spend that much unless I have to . I've spent money in other place like my wife to keep her off my back and keeping my kids happy and in school.
Thanks for tas help when I needed it and I'm still looking for an answer about making my wipers go really fast.
Keep building them bigger and when ya do beat on them hard.
Thanks for tas help when I needed it and I'm still looking for an answer about making my wipers go really fast.
Keep building them bigger and when ya do beat on them hard.
Last edited:
