HAD CV and driveline end. SOLD

[55Willy]

I bought the ends off of Esteban86k5 for my rear driveline but I want to get a dodge 208 fixed yoke swapped on as my rear driveline is way steep and short.

$150. for the two ends just need to add a piece of tubing to length.

 

[twoslo4five0]

can we get some pics please???also what trans is it for???does it have a cv??slip yoke???more info please...

 

[55Willy]

208-241 splines
yes it is a CV style slip.
3/4 ton u joints.

I'll get some pics of it tomorrow after work since it is at the shop.

 

[twoslo4five0]

i still got that fuel pump and stuff if you want to do some trading also...

 

[55Willy]

normaly I would be all for the trade but I got to get the funds to get the dodge pieces so i can put a driveline back in it.

 

[twoslo4five0]

got any pics yet???it will be over a week for me if you dont want to trade...

 

[55Willy]

 

[88K5Jimmy]

Does the CV have the grease fitting?

 

[55Willy]

hhhmmmmm, i'll have to double check.

 

[marv_springer]

So, what size U-joints are those in the CV?

And what size yoke on the axle end?

Marv

 

[55Willy]

no grease zerk in the CV. the joints are standard 3/4 tons...(1350's?)

 

[marv_springer]

Measure the U-joint from end of cap to end of cap.

1350 ==> 3.625"


If both the CV and the axle end yoke is 1350, I'm interested. The slip yoke is 32 spline, right?

Would you take $125 shipped?

Marv

 

[55Willy]

yes it is 32 splines. I know the axle end and the cv has the same size yokes as I held them up to each other. I'll measure the width tonight.

 

[55Willy]

my calipers varified the 3.625"

 

[55Willy]

Sold