So I’m rebuilding my front end on my 85 Jimmy. Chevy 10 bolt not that it matters. I just picked up new hubs and rotors from O’Reilly last night. But I’m looking down at the preinstalled races. The reveal around the race in the casting is very inconsistent. Even though I only need to concern myself with the machined areas. I was wondering if anyone could speak to the integrity of the casting if it’s not consistent all the way around. I will post a video so you can understand.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Hub assembly, casting questions
- Thread starter Bcwkyle
- Start date
Are you saying that the hole is cast off center? That shouldn't cause much imbalance so close to the axis. The bigger question is how much run-out there is to the WMS and rotor when it's installed. Is this the Raybestos hub? Let us know if you have issues with any of the splines. I have no experience, but have read some things.
