hubs for dana 60

[FlatBlackBurb]

i need hubs for a chevy dana 60 because the d60 i got came off of a dually and since the rims are different, the hubs are way longer than they should be. so i just need to swap them out. if anyone has anything PM me or reply here

tommy

 

[sweetk30]

fyi you might want to up date your info. you need hub/rotors. others might think you need lockouts/hubs. good luck. most on here endup buying new.

 

[FlatBlackBurb]

really why do i need new rotors too? just trying to understand a little bit more

 

[Hogback Fabrication]

You don't need new rotors, but you do need new hubs and wheels studs (different length, IIRC).

 

[sweetk30]

cant recall 100% on rotors. but the single rear wheel ( srw ) are stud held on. the dually rear wheel ( drw ) are held on with bolts. i think the holes are a bit smaller if i recall correctly.

 

[FlatBlackBurb]

well if anyone has HUBS for a dana 60, let me know. ill look up the rotors later. etc

 

[4X4HIGH]

Pretty sure you need hubs and rotors. There is a different offset to the rotor IIRC.

 

[Eric M.]

You'll need the rotors as well. The mounting holes are a different size from the dually to single. What you're looking for is refered to as the "Bering Hub", but, I'm sure everyone has figured it out by now!

Good Luck,

Eric M.

 

[94yukon]

I took my set of dually hubs put them in a lathe and turned the casted part off the hub , where the rim bolts to now. then machined the rotor and bearing hub for stock 14b wheel studs to moved the rim in to the same spot the single wheel is ,then used a .25 thick steel ring with the lug stud pattern to make a flat rim surface, its cheap & easy