hydroboost ?'s

[mr250twostroke]

Does anyone have a diagram of all the hose routing I.e. master cylinder, ps pump and steering box.
Secondly the nipple for my reservoir broke off on my clutch master, is that serviceable?
Thanks for any help...

 

[mr250twostroke]

Wish I had better search skills, found this after searching a bunch-
Still haven't found the answer to my clutch master ? though...

 

[1BEATK5]

you talking about the 90 degree plastic outlet? I haven't seen those separate from a new master, so I would say not likely available separate.

 

[mr250twostroke]

you talking about the 90 degree plastic outlet? I haven't seen those separate from a new master, so I would say not likely available separate.

Yes the white plastic cap on top of the master. I'm not sure how one would remove it even if it was replaceable. Sucks cause this master is brand new... oh well.

 

[mr250twostroke]

Easy to remove, just presses in with an O ring. I'll put a nipple on it and push it back in.

 

[6.2Blazer]

Wish I had better search skills, found this after searching a bunch-
Still haven't found the answer to my clutch master ? though...

The factory setup has two seperate return fittings on the pump, one coming from the hydroboost and one coming from the box. The picture here is probaby if you retrofit hydroboost on a truck without changing the pump to the hydroboost specific part, hence the "T" there the two returns hook into.

 

[mr250twostroke]

The factory setup has two seperate return fittings on the pump, one coming from the hydroboost and one coming from the box. The picture here is probaby if you retrofit hydroboost on a truck without changing the pump to the hydroboost specific part, hence the "T" there the two returns hook into.

Yes thank you, I have the hydro ps pump so no tee for me. I assume the smaller pulley is for more volume?