coupeguy2001
Newbie
I am building a 57 cchevy pickup, and acquired a hydroboost and master from an 85 blazer. I bought a new hydrobooster because the old one appeared to be leaking. I used a star spacer between the master and the booster, and was lengthening the pin the thickness of the spacer.
I noticed that the two hydroboost units had different length pins.
I pushed the old hydroboost in and marked the pushrod, then measured it. then pushed in the new one, and the accumulator is holding the piston at max stroke.
How do I get it back to relaxed position?
Anybody???
I noticed that the two hydroboost units had different length pins.
I pushed the old hydroboost in and marked the pushrod, then measured it. then pushed in the new one, and the accumulator is holding the piston at max stroke.
How do I get it back to relaxed position?
Anybody???
