In Reno, NV: 6" 2 V-Belt Pulley and Clutch for York. (SOLD)

[colbystephens]

SOLD.

I have a fully functional clutch and 2 v-belt pulley off of my York compressor. The clutch does properly engage.

I'm open to a trade: I am getting rid of it because I need to replace it with a 6 groove serp. style pulley/clutch.

$40 + Shipping.


P1070968 by colbyjstephens, on Flickr


P1070970 by colbyjstephens, on Flickr


P1070972 by colbyjstephens, on Flickr

The only flaw in this thing is that the wire has a little damage to the insulation, pictured here:


P1070969 by colbyjstephens, on Flickr

No biggie: Just splice your new wire in closer to the pulley than the damaged insulation.

 

[colbystephens]

Ttt

 

[doonjumper]

can you measure the center hole Dia. I think I found a 210 but wanna make sure it fits on shaft. Thanks

 

[colbystephens]

Best I can measure, not having a caliper, the end is 5/8". It's a conical shaft, though. It came off of a long stroke York. I think all the Yorks use the same pulleys.

 

[doonjumper]

Looking to get this one. http://wichitafalls.craigslist.org/cto/3373522427.html I think you are right on the same shaft size on all of them.

 

[colbystephens]

That looks like a smoking deal!


One that would be well rounded out by purchasing this pulley.

 

[doonjumper]

What did you have in mind for trade? $35......+ I pay to
ship?

 

[colbystephens]

I was hoping to trade for a 6 groove serp. pulley.

$35 + the ride would be fine. I'll send you a PM about it after a bit - I'm currently on a break from teaching a class at the moment.