Injector/fuel line problems

[mill5471]

Vehicle is an 85' GMC C30 with the 6.2. Got rebuilt injectors and went to change the old ones out and could only change three. Two problems: 1) can't get socket over passenger side rear injector because of A/C. Im thinking the black A/C cover is going to have to come off. 2) All of the injectors on the drivers side turn before the fuel line breaks loose and i don't want to twist the hard fuel line. Over the last few days i had been spraying the fittings up with PB Blaster, i just went out to try them again and had no luck. I also tried holding the injector with pliers and then turning the fuel line fitting but had no luck either, as it is pretty tricky to with a oil dipstick, master cylinder, brake lines, steering shaft and A/C pump all in that area. Any suggestions?

 

[kennyw]

Buy the correct size wrench that fits the injectors. It should solve both problems.

 

[tRustyK5]

30 mm is the correect size for the injectors. I was able to re&re all the passenger injectors using a deep 30 mm socket, and my truck has AC too.

Rene

 

[mill5471]

Buy the correct size wrench that fits the injectors. It should solve both problems.

Duh, i never really thought about that. Thanks