interesting idea for tube doors..

[twoslo4five0]

anyone ever made them out of square tube??anyone could make a set as long as they had a welder,grinder and a few other tools...im i loosing it or would i think this might actually look good on our trucks??

 

[blazinzuk]

Never seen them on a blazer but I have seen them on a tracker and a toyota, used a square tube die in a bender they looked awesome.

 

[twoslo4five0]

why would you have to bend them??since its square you could just cut all the tubes to the right angles,ect and weld them in place..

 

[twoslo4five0]

here is where i was getting the idea from

 

[B_to_C]

http://coloradok5.com/forums/showthread.php?t=213223

Look at post #27

 

[ct85k10]

something like this http://chevy.off-road.com/chevy/article/articleDetail.jsp?id=200868

 

[dremu]

something like this http://chevy.off-road.com/chevy/article/articleDetail.jsp?id=200868

And by a CK5'er to boot!

-- A

 

[blazinzuk]

Heres the pics of one I like, I also think on our trucks if you put a curve in them it would look awesome. That could be done with a torch just heat and bend http://www.planet4x4.net/forums/suzuki/6931-tube-door-project.html

 

[twoslo4five0]

http://coloradok5.com/forums/showthread.php?t=213223

Look at post #27

thoose look good

here is a latch that bushwacker made for his...