monsterjim
1/2 ton status
Plasma cutter had a bad tip so just had the local machine shop C&C me a bezel out of diamond plate
Turned out pretty good, Got it thrown in last night with all the white faced gauges and wired up. The extra hole next to the tach is for a speedometer, but white faced ones are high dollar, so will have to wait on that.
Gonna get the MSD put in where the glove box used to be and the stereo above it, I bent that glove box piece to conform a little better, and gonna put the toggle switches up there where the middle heat vent used to be. Gotta get a grey dash cover also!
Heres how the MSD will get set up, got the rev limiter control mounted on the outside of the plate.
Anybody got any good ideas on what to do for seats that won't be real expensive, Gonna start on the roll cage this weekend. What do ya thinks so far. Puttin in the poly (somthinoranother) floor from LMC truck and then Rhinoing the back part.
Turned out pretty good, Got it thrown in last night with all the white faced gauges and wired up. The extra hole next to the tach is for a speedometer, but white faced ones are high dollar, so will have to wait on that.
Gonna get the MSD put in where the glove box used to be and the stereo above it, I bent that glove box piece to conform a little better, and gonna put the toggle switches up there where the middle heat vent used to be. Gotta get a grey dash cover also!
Heres how the MSD will get set up, got the rev limiter control mounted on the outside of the plate.
Anybody got any good ideas on what to do for seats that won't be real expensive, Gonna start on the roll cage this weekend. What do ya thinks so far. Puttin in the poly (somthinoranother) floor from LMC truck and then Rhinoing the back part.
