pauly383
Daddy383
My namesake is FINALLY sitting on my garage floor 



Homeboy slightly damaged two pistons , and teardown proved it to be limited to the two pistons . Traded a one piece main 355 I scored previously that needed a bottom end rebuild for this .
I think it was an even trade
4 bolt , '010 block thats not .030 yet so it can be bored , 5.7 rods , and now ...................................................I own a 400 crank that isn't chewed up



I can now save my freshly machined .060 over 350 I got for the Chevelle for the Blazer . And my low miles TBI motor as a spare for my K2500 .
Damn I have too much crap in my single car garage




Homeboy slightly damaged two pistons , and teardown proved it to be limited to the two pistons . Traded a one piece main 355 I scored previously that needed a bottom end rebuild for this .
I think it was an even trade

4 bolt , '010 block thats not .030 yet so it can be bored , 5.7 rods , and now ...................................................I own a 400 crank that isn't chewed up




I can now save my freshly machined .060 over 350 I got for the Chevelle for the Blazer . And my low miles TBI motor as a spare for my K2500 .
Damn I have too much crap in my single car garage

!