Muddytazz
1 ton status
Need one for a 1980 K5 with TH350/205/12b with slip yoke, u-joint center to u-joint center is 32.250". Anyone have one?
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
K5 Rear driveline
- Thread starter Muddytazz
- Start date
Muddytazz
1 ton status
ttt
dodgedude99
1/2 ton status
would the slip yoke from a 208 work?
i have my original drive shaft thats going to be about 1' too short.
i have my original drive shaft thats going to be about 1' too short.
Muddytazz
1 ton status
I don't need the slip yoke end, my slip yoke is good, I need the driveline between the slip yoke and the rear axle.
I didn't think about that, but what is the length ujoint to ujoint of a stock driveshaft from a fixed yoke TH350/NP205 combo? Putting the slip yoke on another driveshaft that is the correct length wouldnt be hard.
Muddytazz
1 ton status
u-joint center to center needed is 32.250
Muddytazz
1 ton status
Still looking 
