Looking for a set of k5 gas tank cross members, would prefer a set 81+
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Wanted K5 Tank Crossmembers
- Thread starter Babaganoosh
- Start date
last time i needed some for a k30 blazer tank swap i just made them from a few lengths of angle iron .
but if someone has them it might be faster . good luck .
but if someone has them it might be faster . good luck .
oh i forgot ........ STRONGER also .
Hmm, I need to read some build threads and see what you guys are doing.
Shorty the crewcab. (Been saved from the chopping block)
few pics of the angle iron brackets i made to hold the blazer 31 gal tbi tank and install in a k30 long bed . hope this gives you a few ideas . the 45* notches are or wires or fuel lines to pass threw . the rear unit also replaces the old o.e.m. stamped steel tin cross member .
ck5.com
my bracket pics . picking up most factory holes . the rear one replaces that tin stamped crossmember . then @shady and his tank swap he did .
check out your build thread, I posted some photos from my LWB K10. Stupid simple.....
1982 C/K 6.0L Caitlyn Mall Crawler (Interior time)
Don't want to cut the bed any, also not very good at body work If you don’t cut it, there’s much less success Besides, with all the other mods on the truck, why is the bed some religious piece of livestock?
ck5.com
I forgot about that, I really need to sit down for awhile and research or save pictures.
Have some from a 89 k5. In NW Washington
Can you post some pictures?
Can get some in the next couple days
