uglychevyZZ4
3/4 ton status
well it has to go,and I dont have money or time to finish it. I thought I could keep it but I have to get a new roof on my house before fall gets here.
ALMOST NEW
all brakes
gears
windshield
swampers
radiator
carb
front seats
water pump
axles
D44 front
flattops
new 4:10 gears
new bearing & seals
warn hubs
new clipers & brakes
new hub bearings
good rotors
Rear 14FF
van width
4:10 gears about 2k on em
all new brakes, cylinders etc..
drums at max machining.
suspension
5" rear shackle flip lift, homeade cut & drop style
(have 56's for it and another shackle perch to use, then 52's can go up front)
Front rancho 6" that has 1 leaf removed to soften ride, sits about 5".
engine & drivetrain
350 sbc
new edelbrock carb, 600cfm elec choke
polished dual plane intake
above stock cam
67 camaro rs/ss sbc 350 rods/crank
accel HEI & super coil
new module
new wires
120 amp alt..
bottom end has 2000 miles on it
rings are tired, and valve guide seals are worn.
has some smoke, LOADS OF POWER though.
headers are old beaters, but work
sm465, seems tight, never any problems
np205, seems tight, never any problems
Body & Chassis
chassis has NO cracks anywhere even the steering gearbox area is perfect.
body is cut on front lower fenders and the rear, havent narrowed the front yet, stock bumper going back on it.
rear has dents in panels and has been narrowed for truggy style, narrowed 42" ...see pic, or i can email more.
interior has new seats, good dash, cluster etc, carpet is getting ripped out now, was gonna herculine it.
good panels n headliner.
has rear seat too, still fits with narrowed rear /forums/images/graemlins/thumb.gif
tires
SSR radial swapmers, 35x12.5x15...2000 miles on em, no rock rash, no leaks.(these were 1200 alone)
Im sure theres more im forgetting...must go, 1500 cash or 1000 and trade... atv? dirtbike?
[email protected]
ALMOST NEW
all brakes
gears
windshield
swampers
radiator
carb
front seats
water pump
axles
D44 front
flattops
new 4:10 gears
new bearing & seals
warn hubs
new clipers & brakes
new hub bearings
good rotors
Rear 14FF
van width
4:10 gears about 2k on em
all new brakes, cylinders etc..
drums at max machining.
suspension
5" rear shackle flip lift, homeade cut & drop style
(have 56's for it and another shackle perch to use, then 52's can go up front)
Front rancho 6" that has 1 leaf removed to soften ride, sits about 5".
engine & drivetrain
350 sbc
new edelbrock carb, 600cfm elec choke
polished dual plane intake
above stock cam
67 camaro rs/ss sbc 350 rods/crank
accel HEI & super coil
new module
new wires
120 amp alt..
bottom end has 2000 miles on it
rings are tired, and valve guide seals are worn.
has some smoke, LOADS OF POWER though.
headers are old beaters, but work
sm465, seems tight, never any problems
np205, seems tight, never any problems
Body & Chassis
chassis has NO cracks anywhere even the steering gearbox area is perfect.
body is cut on front lower fenders and the rear, havent narrowed the front yet, stock bumper going back on it.
rear has dents in panels and has been narrowed for truggy style, narrowed 42" ...see pic, or i can email more.
interior has new seats, good dash, cluster etc, carpet is getting ripped out now, was gonna herculine it.
good panels n headliner.
has rear seat too, still fits with narrowed rear /forums/images/graemlins/thumb.gif
tires
SSR radial swapmers, 35x12.5x15...2000 miles on em, no rock rash, no leaks.(these were 1200 alone)
Im sure theres more im forgetting...must go, 1500 cash or 1000 and trade... atv? dirtbike?
[email protected]
