Looking for misc manual trans conversion parts, SM465

[moneypit_K5]

I need a:

SM 465 bellhousing,(V8)
Zbar,
knob for bellhousing,
arm from pedal assembly through floor,
clutch pedal itself...NOT the entire assembly, just the pedal.

My shipping Zip is 98660, let me know the damage.

Thanks guys!

 

[fallout232]

Ive got most of what you are looking for. I have got the Z-Bar, The bellhousing minus knob, and the arm that goes from the pedal to the z-bar through the floor. Let me dig through my stuff tonight and I will post up some pics for you.

 

[moneypit_K5]

I dont really need pics, just what your gonna charge me to send it to 98660 as soon as possible.

 

[fallout232]

Sorry for the Delay, I had to dig through my piles of parts to find this stuff, As always it was at the very bottom of the Pile.

Shipping via UPS Ground will be about 15.00 I would like to get 40.00 plus the ride for what I have pictured so 55.00? Shipped.

The Z-Bar comes with the Attatchment that bolts to the Frame, There is also what I believe is the rod that attatches to the Clutch fork on the other end of the Z-bar that is included.

The Clutch Pedal to Z-Bar Rod will need new Cotter pins and washers on the ends, The old cotter pins were rusted out and I mangled them removing it.

The Bellhousing is "Dirty" however there is no Visible cracks. I do "not" have the clutch fork or the Boot that goes with it. The Pivot Ball "Inside" the bellhousing is present however it has rust on it. It could use either a good wire wheeling or replacement. the Bellhousing to transmission bolts are included. I do not have the "Knob" that screws into the outside of the Bellhousing by the shift fork.

 

[moneypit_K5]

Sounds ok by me, you do paypal? pm me you accnt name if so, I'll get some moneys to you.

Do you have the clutch pedal itself then or no?