Loud jingle-jangle when I shut the engine off.

[colbystephens]

What's up with that? Been that way for a LONG time. If I put the clutch pedal in while I shut the engine down, there's no jingle. Makes me wonder if the throw out bearing is spinning on the shaft or something. The transmission operates very normally. thoughts?

 

[cheyennek20]

Broken clutch fork. Mine did that until I replaced it.

Well, thats what was causing mine.

 

[colbystephens]

Broken clutch fork. Mine did that until I replaced it.

Well, thats what was causing mine.

wouldn't that prevent my clutch from operating?

 

[cheyennek20]

Mine was only broke on one side. One of the teeth that goes into the throw-out bearing was Gone.

I replaced it with:
http://www.jegs.com/i/McLeod/673/16931/10002/-1

It's been a while and I can't find the packing list, but I'm pretty sure that was the one I got.

Now, I'm not saying that's the cause, but , from what you described, that's VERY similar to what I had.

Hope that helps.


Plus, I replaced my clutch, pressure plate, throw-out bearing, pilot bearing, and flywheel at the time, ...so, again, I'm not exactly sure.

 

[toomany]

Mine makes noise when I shut it down off. Unless I shut it off in gear and coast to a stop while pushing the clutch in. My problem is the trowout bearing. Still shifts fine, does not whine...just a little rattle when I kill the motor. Been that way for a year or so. Not something I plan on pulling the trans to replace (unless it actually comes appart).

 

[colbystephens]

that's not real reassuring.

 

[cegusman]

Was happening to mine. Ended up being the front input bearing on the trans was bad.