TN LS engine mounts/ORD cross member

[drew4x4]

LS swap engine mounts. Slider style, similiar to dirty dingo's, but with much better welding. You can move the engine back and forth by 2". Sand blasted and painted.
$100 shipped



32 spline high angle drive line slip yoke eliminator np205 flange for a, u bolt style, brand new, never used. 1350 ujoint.
$60 shipped

Stock angle mounts from an 80 - sand blasted and painted.
$60 shipped

14bolt axle disk brake conversion brackets - newly painted
$60 shipped


complete set of spicer ball joints for a dana 44. uppers and lowers. brand new. non greasable.
$60 shipped

View attachment 158596

View attachment 158599

 

[drew4x4]

to the top



engine mounts and cross member have been dropped off for sand blasting - i'm gunna paint em and try to sell em

 

[drew4x4]

all painted

 

[drew4x4]

bump

 

[drew4x4]

ttt

 

[drew4x4]

bump

 

[K5Luisg]

will that crossmember clear a ls swap?

 

[drew4x4]

yea, it will. i had it bolted up with my engine, which was a 6.0, and it cleared. it had about a 1/2 inch clearance between the oil pan and the cross member. its tight. mine is a LQ4 with the truck oil pan - the deepest oil pan on LS engines.

 

[K5Luisg]

awesome I have a lq4 aswell. let me get the funds together and ill pm you.

 

[drew4x4]

Here's a picture of it in the truck. I didn't take any pictures when I put the engine in, sorry. I remember just being able to get my fingers between the cross member and the oil pan.

 

[down4thakrown]

These still available?

 

[drew4x4]

yup all available.

 

[drew4x4]

engine cross member sold.

 

[mudman83]

Do you have the angle mounts still?