M1009 Gen 2 Part Number

[Doc Feel Good]

Guys,

I know its posted or someone has it handy, but does anyone have a part number for a replacement alternator on my M1009.

According to the idiot lights, it is GEN-2 that is going out.

Thanks

 

[wackojacko85]

According to Steel Soldiers Wiki page...
http://www.steelsoldiers.com/showwiki.php?title=wiki:Cucv
This is towards the bottom. Hope it helps. Since im not sure if GEN#2 is passenger or driver side

Dual 100 amp alternators wired in series to make the 24V. Very strong charging system that will handle any load you can toss at it. Changing over to 12V is NOT recommended.

The Passenger side Alternator MUST HAVE a isolated Ground. The Driver side does not. A Autozone Part number for the DRIVER side alternator is DL7157 (also found in a 1975 cady with a V8 engine) This Alternator is 78 AMP and works just fine. You MUST have a Isolated Ground Alternator for the passenger side. Ebay, www.saturnsurplus.com, and many other places stock this alternator.

NAPA has a remanufactured Isolated Ground Alternator. WIL 90014277. Wilson Alternator rebuilds them. Cost ~$220. Just make sure you test the alternator before you install it. They have had some issues with the rebuilds of NOT being isolated grounds.

27si Type 100 Series

 

[Dabba]

Check the connections on all the wires. Make sure the connections to the battery terminals are good and the batteries are good. I wouldnt look for a replacement, get it rebuilt. I tried for a replacement and it wasnt the same.

 

[Doc Feel Good]

Thx guys, I will get mine rebuilt. Truck runs, just need it fixed.

 

[Dabba]

Good luck.

 

[wackojacko85]

http://www.cucvelectric.com/index.html

I saw this one the other day. It's a rebuild kit. Don't know if it's any good or not.

 

[sixb]

Thx guys, I will get mine rebuilt. Truck runs, just need it fixed.

I had both mine rebuilt locally for around 100.00 each a couple years ago.