77crewcab
1/2 ton status
Hey guys I need a measurement for a stock rear driveshaft on a K5 with 700/208 combo . Need from center of the ujoint on the axle to center of the ujoint on the slip yoke. Thanks.
CK5
Register an account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members.
Measurement needed
- Thread starter 77crewcab
- Start date
shaun89
1/2 ton status
29.5"!
77crewcab
1/2 ton status
Thanks!
77crewcab
1/2 ton status
That seems pretty short, are you sure that is the right length?
You need to remember that if the vehicle is lifted that will change the length required.
77crewcab
1/2 ton status
Yeah but is it really that short for a stock shaft? Just talking about the actual shaft not the slip yoke part.
reddog64
1/2 ton status
my 78, with 350/400/205 dana 70hd moved back 3.5 inches was 43"
Np205 was converted to fixed yoke.
rear is 56's with a zero rate and shackle flip.
Np205 was converted to fixed yoke.
rear is 56's with a zero rate and shackle flip.
77crewcab
1/2 ton status
Thanks, but again I am looking for the length of a stock driveshaft with a 700/208 combo. Just the ujoint to ujoint measurement.
77crewcab
1/2 ton status
TTT anyone?
He's right, it's 29.5". That's what my stock shaft was and the spare stock in my garage.
Rick
Rick
shaun89
1/2 ton status
ya, i measured again just so i dont feel stupid, still 29.5", it does seem real short though. but its a k5...
77crewcab
1/2 ton status
Okay cool I didn't mean to sound like I was putting your measuring skills in question. That just seems really short. Thanks guys!
